DELBOND BM 200 54920
General description:
Delbond BM 200 54920 is a thin insulating and bonding product made of woven glass and G-11 epoxy resin with mechanical properties at high temperatures.
Main characteristics:
Delbond BM 200 54920 consists of a base layer of woven glass impregnated with a cured epoxy resin which is then laminated with a semi-cured layer of epoxy resin on each side.
Application:
Delbond is mainly used for bonding and insulating in one operation, copper bar rotor coils of turbine generators.
Delbond BM 200 is particularly suitable for the insulation of coils end windings but also the straight parts or rotor bars.
The advantage of the high performance DELBOND BM 200 is the high precision assembly application. Their design ensures a low reduction of thickness after the pressing process and enables the use of automatic insertion machines.
This type of Delbond, to the opposite of Delbond BM for example, do not enable to smooth out irregularities on the surface of the coil.
Cure Conditions:
In order to obtain good bonding and optimum results, DELBOND should be cured for 1 hour in a press at a temperature of 160°C under a pressure of 150 N/cm².
Storage Conditions:
DELBOND may be used up to 6 months after the date of delivery if kept in its original packaging and at a temperature lower than 25°C or 12 months at a temperature of < 4°C.
Packaging:
DELBOND is supplied:
- in rolls with a length of approx. 1070 mm
- in tapes of width >= 10+/- 0.2 mm
The length of the roll has to be defined in accordance.
For other dimensions, please consult us.
Please consider that minium quantities might be requested to produce this reference. Please consult us.
|
Value |
Test norm |
|||
|
Physical properties |
||||
|
Average thickness as received |
mm |
0,28 |
||
|
Average mass per unit area |
g/m² |
400 |
||
|
Thickness after pressure cycle: 1 hour -160°C -150 N/cm²: |
mm |
2 layer 0,22 ± 0,02 |
||
|
Tensile shear strength according to specific test at 20°C |
N/cm² |
> 500 |
||
|
Tensile shear strength according to specific test at 155°C |
N/cm² |
> 150 |
||
|
Electrical properties |
|
|||
|
Breakdown voltage when pressed : 1 hour -160°C -150 N/cm² |
kV |
>12 |
||
The product properties set forth in this data sheet are based on the results of testing of typical material produced by the affiliated companies of World Industry. (underneath referred as World Industry). Some variation in product properties is typical. Comments or suggestions relating to any subject other than product properties are offered only to call the end-user's or other person's attention to considerations which may be relevant in the independent determination of the use and/or manner of use of product. World Industry does not claim or warrant that the use of its product will have the results described in this data sheet or that the information provided is complete, accurate or useful. The user should test the product to determine its properties and its suitability for the intended use. World Industry expressly disclaims any liability for any damage, harm, injury, cost or expense to any person resulting directly or indirectly from that person's reliance on any information contained in this data sheet. Nothing contained in this data sheet constitutes representation or warranty as to any matter whatsoever. World Industry makes no warranties whatsoever in this data sheet, expressed or implied, including any implied warranty or fitness for a particular use or purpose. World Industry shall in no event be liable for incidental, exemplary, punitive or consequential damages.
